MT200 Floor Lacquer

The ideal residential wood floor lacquer.

MT200 Floor Lacquer is a one-component water-based wood floor lacquer for easy and convenient use in light traffic residential/domestic areas.

Fast drying, low odour and and non-yellowing.

For previously sealed as well as for new or sanded old floors.

MT200 Floor Lacquer is also suitable for lacquering all kinds of indoor woodwork. 

MT200 Floor Lacquer has received the Danish Indoor Climate Labelling. A product with this labelling has undergone extensive volatile emission and odour tests. This ensures that there are no chemical substances in the product which adversely affect the air quality in the room.

For professional use only.

Available in: 5 litre.

Gloss Finishes: Ultramatt, Matt, Silk Matt.

How to apply ProFinish

Untreated/sanded floors:

Ensure that the surface is absolutely clean, dry and free from all dust, wax, grease, polish and soap residues etc. Sand the surface to remove dirt and irregularities. Vacuum thoroughly and wipe off with a cloth well wrung in clean water.

  • Apply Junckers WB Primer and leave to dry.

  • Sand with sandpaper grit 150-180 along the fibres of the wood.

  • Vacuum sanding dust and wipe off with a cloth well wrung in clean water.

  • Apply one coat of MT200 Floor Lacquer.

  • Leave to dry overnight and then apply the final coat of lacquer.

Previously sealed floors:

  • Wash with Junckers Neutralizer.

  • Sand thoroughly using grit 150-180.

  • Vacuum sanding dust and wipe off with a cloth well wrung in clean water.

  • Apply one coat of HP200 Floor Lacquer and leave to dry.

  • Before lacquering the full area, it is recommended to conduct a trial application on a smaller area.

How to conduct a trial application:

Lacquer a couple of spots, 2 coats at 4 hours interval. After drying for 24 hours check the spots for adhesion by scraping with the edge of a coin. If the adhesion is functioning and the appearance of the surface is acceptable, the floor can be lacquered. If the result is not acceptable, continue as described under “Wax/polish treated floors”.

Wax/polish treated floors:

  • Machine sand by first using grit 24-36 to strip old coats.

  • Then remove abrasion marks using grit 60-80.

  • Finally, use grit 120-150 to obtain a completely smooth surface. Vacuum thoroughly.

  • Treat the floor as described under “Untreated/sanded floors”.

 

We’re here to help

If you want to get the most out of your Hardwood Floor, talk to the experts. Connect with the Hardwood Technology team today.